Skip to main content
All CollectionsHelp ArticlesApricot Native ReportingBuilding And Formatting Reports
How do I load new data after opening a report? (Native Reporting)
How do I load new data after opening a report? (Native Reporting)
Updated this week

Adjust Auto Run Settings for Entire Report

Auto Run affects whether or not data is generated by a report every time you access the report in Run or Edit mode. When Auto Run is enabled, your report will automatically load all your report data as soon as you open the report. This can create problems when very large reports stall out or freeze during loading, so you may find it necessary to turn Auto Run off for some reports. Auto Run can be turned on each time a report is run or edited by clicking a button embedded within your report; it can be enabled by any user with access to your report. These new settings affect how the report runs automatically when it is opened by a user.

  1. To access Auto Run settings that will affect an entire report, click the top or report level gear box at the top of your report.

  2. You can set Auto Run to be enabled or disabled for an entire report in Edit Mode.

  3. You can set Auto Run to be enabled or disabled for an entire report in Run Mode. This setting will also affect report bulletins you may have on your Apricot landing page.

    1. Note: Settings that are changed here will override any settings at the section level. If you make changes to Auto Run at the section level, these checkboxes will disappear at the report level.

  4. When you have finished making adjustments, click Apply.

Did this answer your question?